Hello coders, i need to know how to bill out a crushed canellous allograft Is it ususally considered a part of the surgical bundle I did fill the defect with demineralized bone matrix and some crushed cancellus bone This was packed in there very tightly This was viewed under fluoroscopy and felt to fill the void very nicely A tricortical graft was then obtained with a sagittal saw and osteotome
Gelfoam and thrombin was then placed into the iliac crest after scooping out cancellus bone graft with a rongeur The wound was then copiously irrrigated Macropore was then contoured to fit over the iliac crest defect and held in place with 3 reabsorbable pins. The softer cancellus bone in the exposed glenoid face made the case significantly more difficult as it made adequate anchor placement difficult Traditionally bankart repairs with bone involvement takes approximately 2 hours to complete. An osteoarticular bone allograft (20932) consists of bone, articular (joint) cartilage, and other soft tissues that is used to replace large defects.
Minor or small (eg, dowel or button) or 20902 major or large At this time, under fluoroscopy, the lateral wall of the calcaneus was marked out The double loaded sutures from each anchor were passed through the bone tendon junction of the lesser tuberosity fracture fragment Procedure performed medal meniscal repair [29882] debridement acl graft and allograft bone grafting and debridement of femoral and tibial tunnels cpt ?? Am unsure of how to code for this debridement and bone grafting for the acl staged revision.acl graft was debrided with use of shaver An 8 spacer was placed in femoral tunnel
Guide pin drilled into bone. I believe c9359 is for the injectable putty & c9362 is for the moldable putty, but what do you use for a structural bone allograft
WATCH
