Have been looking at used sentra's, altima's, maxima's and rogue's for the last few weeks Finding out more and more information we have come across a lot of reviews with transmission problems for all of these vehicles. Hi, there is a loud grinding noise coming from the front side of the car when ever i reverse Is there any ideas where cause i can't seem to pin point the location of the sound. In short, the nissan consult 3 plus v241 software is a versatile and reliable tool that supports key programming for nissan infiniti vehicles and provides a variety of features to enhance your diagnostic and programming capabilities. How many people are having the issue where the cruise control shuts off and the message “forward driving aids disabled
Front sensor blocked” comes on This happens every few miles now Pulling over, shutting off the engine, and restarting it resets the system, but it cuts out again Have you had any issues/problems with your 2025 murano I am close to purchasing one in early may I would appreciate your feedback/opinions relating to your actual experiences (especially issues/problems) with your new 2025 nissan murano
When the vehicle is in reverse, the side mirrors rotate down to see the road, but the driver side mirror only come back to normal about 60% of the time Similarly, the driver side mirror sometimes doesn't rotate outward (from. There's no cheat for nissan cvt's in general, and no provision for doing it with a generic scan tool Below is the procedure if you obtain a capable tool Once you get it erased, the tcm will read the new data the next time the ignition is turned on If it doesn't take for any reason, check the cvt connector and wiring.
Hi, i have a 2021 rogue sv Both of my rear doors have issues time to time where they don’t respond to the unlock/lock button on the key fob, the buttons on the driver side door or the exterior unlock buttons on each handle If i press the unlock/lock button on the rear door exterior handle it. After replacing mass air flow sensor, light came back Went back and read codes but this time p0101 is back plus reprogram ecm Can there be something else besides that?
